PRE-ORDER (4 to 6 WEEKS) NEW Stainless Steel S-1 Slide Hinge System for the BULLSEYE GRILL.

  New STAINLESS STEEL Model S-1 Slide hinge.                                           

This all NEW Generation S-1 high lift slide hinge is the NEWEST and latest design. It was designed to fit the REC TEQ Grills " Bullseye "( Both the 380 and the 380X deluxe models). This hinge makes it possible to use the REC TEQ Grills  "Matador skillet" and ALL ( 22 -Inch Kettle Rotisserie that measure less then 6 3/4 inch tall.) With this hinge system on the Bullseye Grill, you have the ability to use the factory lid as it was intended to be used.

   Once you get your new S-1 hinge, just simply remove your factory hinge and store it, you will never need to use it again. Then install your new S-1 hinge in it place. Anytime you wish to switch from factory configuration to the Matador or Rotisserie configuration. Simply loosen the two thumb screws, open the lid install your Rotisserie, Pizza oven or the Rec Teq Skillet, lift the lid by the handle on the lid and the handle on your new S-1 Hinge and set it on top and tighten down the thumb screws and you are all set. When you want to go back to factory config, just loosen both thumb screws, lift the lid and place it in the parked open position, remove your Rotisserie or skillet. Set the lid into the closed position as shown in the video, and retighten the thumb screws and you are done.  It truly is just that easy. I hope this helps open up a whole new world of cooking on your AMAZING Rec Teq Grills Bullseye "RT-B380". 

PLEASE keep in mind, "NEVER" close the lid while the hinge is in the lifted position without the Matador, Rotisserie or other products in place, doing so could result in damage to the Bullseye lid or grill.

CAUTION. Do not attempt to raise or lower the hinge right after cooking, as it is made of 11 gauge stainless steel, and will remain very hot long after you have turned the grill off. Wait for it to completely cool to avoid burn injuries.

((Please,  Take a few minutes and watch this videos.  It not only will show you the proper way to open and close it. It will give step by step install directions.